Profile Picture

3D Scanned Model in HEADSHOT 2 is low poly with twisted face in Mesh to Head-HEAD GEN Step

Posted By nickbryantcali 3 Years Ago
You don't have permission to rate!

3D Scanned Model in HEADSHOT 2 is low poly with twisted face in Mesh...

Author
Message
nickbryantcali
General.png
nickbryantcali
Posted 3 Years Ago
View Quick Profile
New Member

New Member (75 reputation)New Member (75 reputation)New Member (75 reputation)New Member (75 reputation)New Member (75 reputation)New Member (75 reputation)New Member (75 reputation)New Member (75 reputation)New Member (75 reputation)

Group: Forum Members
Last Active: 2 Years Ago
Posts: 1, Visits: 46
I hope someone could help. Tried a couple of times aligning points to a different spot. The outcome only got worse. 
I use KIRI Engine's Lidar 3D Scanning with high poly counts as you can see the model in Blender. However after I imported the head to CC4.3 it looked like low poly model. I don't know if low poly was the culprit of the twisted mesh output from HEAD GEN of HEADSHOT. Or it's the setting issue of HEADSHOT that I did not know. Please give me some advice as I'm hitting my head on the desk right now...Thank you!https://forum.reallusion.com/uploads/images/0a5bcec6-d328-46c8-af36-aec7.png 
https://forum.reallusion.com/uploads/images/e74f57f2-7d3e-4d8c-9397-3fca.png

https://forum.reallusion.com/uploads/images/3d12eaf5-57a2-47c7-9561-1916.png

https://forum.reallusion.com/uploads/images/8a442623-85e8-432d-8c7e-e4a1.png
https://forum.reallusion.com/uploads/images/aaf08a8a-976b-4921-80e2-a175.png
luke (RL)
luke (RL)
Posted 3 Years Ago
View Quick Profile
Distinguished Member

Distinguished Member (1.4K reputation)Distinguished Member (1.4K reputation)Distinguished Member (1.4K reputation)Distinguished Member (1.4K reputation)Distinguished Member (1.4K reputation)Distinguished Member (1.4K reputation)Distinguished Member (1.4K reputation)Distinguished Member (1.4K reputation)Distinguished Member (1.4K reputation)

Group: Power Developer
Last Active: Last Year
Posts: 289, Visits: 5.6K
Hi, nickbryantcali

Try to add some extra point on top of head in the "Align Points" section then press the "Head Gen", it should solve the issue.

thanks,



Reading This Topic