I can easily export to ZBrush from CC3, but for some reason, I cannot get the teeth to transfer to ZBrush with the body. I have tried re-exporting several times to no avail. Below are my settings. There is not a specific "Teeth" button to check, just mouth interior. I have the mouth open on the character just a little to show the teeth. Any help from the community would be great!

85% of original size (was 595x420) - Click to enlarge

85% of original size (was 595x420) - Click to enlarge

They will show up in a different tool section. Just append them into the one with the character.

85% of original size (was 595x420) - Click to enlarge

I just moved the mesh of the teeth so you could see it changes it. Then send ALL back to CC.  And update mesh only.

85% of original size (was 595x420) - Click to enlarge

85% of original size (was 595x420) - Click to enlarge

Reallusion Marketplace Store
Content Store Featured Developer Page

85% of original size (was 595x420) - Click to enlarge

Thanks for taking the time to assist! However, I still don't have the same screens that your initial one shows. As often as I have tried to click around to get the meshes to appear in the right side of the window, it just will not. I'm sure I am missing something simple. Again, thanks for taking the time to assist!

85% of original size (was 595x420) - Click to enlarge

That's because you don't have the teeth and other items selected. You only have the character selected. Notice that all of mine are selected and blacked out. And your's on has 1 selected and blacked out.

85% of original size (was 595x420) - Click to enlarge

Left click on the character. Then hit control and left click on the others to highlight them one by one, or shift + left click to group highlight them.

Reallusion Marketplace Store
Content Store Featured Developer Page

85% of original size (was 595x420) - Click to enlarge

Yep, that worked. Tip of the hat in thanks!