I am using iClone 7.73 on Win 10.  I created iClone project, imported character from cc3, and brought in several motion files from perception neuron through 3Dx.  I added the motion files to the timeline, but when I go to playback, the playback stops at 1800 frames.  I tried going to project settings and increasing my Total Frames to 7000, but the timeline playback always stops at 1800 frames.  Tried getting out of project after increasing Total frames, but still stops at 1800.  Any help would be appreciated.
Thanks -kent

If you have changed the length in Project Settings, then also make sure that your Mark IN and Mark OUT indicators are set correctly. See the page below for where to find these (numbers 14/16).

https://manual.reallusion.com/iClone_7/ENU/Pro/Default.htm#iClone_7/7.7/04_Introducing_the_User_Interface/Play_bar_and_play_control_pane.htm


                                                                

Peter
Forum Administrator

www.reallusion.com

Out markers.  That was it.  Thanks for the help.  -kent

Out markers.  That was it.  Thanks for the help.  -kent